Countdown Timer
Enter Hours, Minutes, and Seconds—default is one minute—then press Start. The result panel shows Duration HH:MM:SS with total seconds remaining and ticks down each second until zero.
Set a duration and press Start.
About this tool
This countdown timer converts the three fields into total seconds, formats them as HH:MM:SS, and decrements once per second in the browser. Minutes and seconds must stay in 0-59; a zero total is blocked so Start never begins an empty timer.
How to use
- Open the timer: Load the page with Hours, Minutes, Seconds, Start, and Reset.
- Enter the duration: Type whole numbers for each field; defaults are 0, 1, and 0.
- Press Start: Start validates the duration and begins the live countdown in the result div.
- Press Reset when done: Reset stops ticking and restores the idle message so you can set a new duration.
Common use cases
- Time a short cooking step when you only need minutes and seconds on screen.
- Run a presentation segment countdown visible beside your slides.
- Pace interval workouts with a one-minute or custom second target.
- Keep a meeting break honest by starting a visible browser countdown.
Tips
- Minutes and seconds above 59 are rejected; convert overflow into hours first.
- Press Reset to stop the live tick and clear the result back to the idle prompt.
FAQ
What does the result line show?
Duration HH:MM:SS plus the remaining total in seconds, updating each second.
Why is 0:0:0 rejected?
Duration must be greater than zero; Start shows an error instead of ticking.
Can minutes be 90?
No. Minutes and seconds must be 0-59; use Hours for longer spans.
Does the countdown run on a server?
No. Timing runs locally in your browser after you press Start.